Stihl RT 5097.1 Manual De Instrucciones página 44

● Remove the grass catcher box.
( 13.10)
● Remove the discharge chute. (
Pushing in the mowing deck:
● Position the V-belt in the opening in the
V-belt cover so that it is accessible and
can be attached.
Push the mowing deck (1) under the ride-
on mower either from the left or right.
● Select the lowest cutting level.
Risk of injury!
In the lowest cutting level, the
cutting height adjustment lever is
under tension. Do not touch the
cutting height adjustment lever
during installation of the mowing
deck.
42
Attaching the mowing deck at the front
(RT 5097, RT 5097 Z):
15.5)
Pull the front mowing deck mounting (1)
downwards and hold. Raise the mowing
deck slightly with one hand and insert the
mounting pin on the mowing deck into the
bore on the front mowing deck
mounting (1). Insert the cotter pin (2)
through the bore in the mounting pin.
● Repeat this procedure on the other
side.
Attaching the mowing deck at the front
(RT 5112 Z, RT 6112 ZL, RT 6127 ZL):
Swivel the front mowing deck mounting (1)
downwards and attach to the mowing
deck (2) as shown. Push the mowing
deck (2) to the rear, attaching the front
mowing deck mounting (1) to the mowing
deck.
Fitting the V-belt onto the tension roller
RT 5112 Z, RT 6112 ZL, RT 6127 ZL:
Press the cover (1) downwards and hold it.
Push the locking pin (2) approx. 0,5 cm
upwards. Fit the V-belt (3) onto the tension
roller (4).
0478 192 9813 C - EN