BONFIGLIOLI Vectron ACTIVE CUBE Guia De Inicio Rapido página 76

Code
SF000 No Error
SF001 The value entered for parameter
SF002 The value for parameter
376 and
SF003 The value entered for parameter
Correct the value.
SF004 The calculated slip frequency is negative. Correct the values entered for parameters
and
Rated Frequency
GB
SF005 The calculated slip frequency is too high. Correct the values entered for parameters
and
Rated Frequency
SF006 The calculated total output of the drive is lower than the rated power. Correct the value entered for
parameter
SF007 The set configuration is not supported by the guided commissioning. In these instructions, configurati-
ons 110 and 410 are described. Select one of these configurations for parameter
Code
SF011 The main or leakage inductance measurement has failed because the motor has a high slip. Correct the
SF012 rated motor values in parameters 370, 371, 372, 374, 375 and 376. Carry out the guided commission-
ing once again. In case an error message is displayed again, enter the value 110 for
ter
Configuration
Carry out the guided commissioning once again.
SF021 The measurement of the stator or rotor resistance did not deliver a plausible value. Check the cables at
SF022 the terminals of the motor and the frequency inverter for proper connection and check the contacts for
corrosion and safe contact. Repeat the parameter identification
SF026 Setup aborted
76
Error messages during guided commissioning
Rated Current
Rated Current
370. Correct the values.
Rated Voltage
Rated Cosinus Phi
375.
375.
376.
Rated Mech. Power
Error messages after parameter identification
30 (sensorless regulation according to U/f-characteristic) if value 410 was set so far.
Quick Start Guide ACU 201, ACU 401, ACU 501, ACU 601
Meaning / Measure
371 is too low. Correct the value.
371 is too high, referred to parameters
374 is wrong (greater than 1 or smaller than 0.3).
Meaning / Measure
Rated Mech. Power
372
Rated Speed
372
Rated Speed
30.
Configuration
05/16