3 Mechanical installation
WARNING
•
During installation, comply with the following installation and safety instructions as well as the
installation and safety instructions of the co-applicable documents.
Mount the devices with sufficient clearance to other components so that the cooling air can cir-
•
culate freely. Avoid soiling by grease and air pollution by dust, aggressive gases, etc.
Make sure that no foreign particles (e.g. dust, chips, wires, screws, tools) can get inside the fre-
•
quency inverter.
•
Install the frequency inverter on a non-flammable surface.
The frequency inverter may only be installed in vertical position.
•
•
Screw the frequency inverter on a metal surface (unpainted).
•
The frequency inverter must be grounded.
For equipotential bonding, connect the frequency inverter, electrical cabinet, motor case, filter,
•
etc. to a common grounding point via short cables.
b
c
b1
b1
x
a
a1
a2
x
≥
x
100 mm
b
b1
x
a1
a
a2
x
≥
x
100 mm
05/16
ACU201 Sizes 1 and 2 (up to 3.0 kW)
ACU401 Sizes 1 and 2 (up to 4.0 kW)
c1
Screw fixing brackets to heat sink and mounting plate.
ACU201 sizes 3 and 4 (4.0 to 9.2 kW)
ACU401 sizes 3 and 4 (5.5 to 15.0 kW)
c
c1
Quick Start Guide ACU 201, ACU 401, ACU 501, ACU 601
Top fixing bracket
(screws M4x20)
Bottom fixing bracket
(screws M4x60)
Screw fixing brackets to heat sink and mounting plate.
GB
51