Electrically Connecting The Pump; Test; Switching On The Eps - Bosch 1 687 010 183 Instrucciones De Funcionamiento

en 2� | � ��� ��� ��� � � ��� ��� ��� | Preparations for testing
�.�

Electrically connecting the pump

Procedure:
1
Fig. 8: Electrical connection
Schematic
Delphi
2
IMV
2 1 684 460 2XX
1
458800-7
¶
Attach the ZME connecting line (3) using the adapter
line 1 684 460 270 or 1 684 460 284 provided (2) to
the IMV (1) of the Delphi pump.
|
1 689 979 986 2009-12-11
2
CRE 800
1 684 460 251
oder/ or/ ou/ o
1 684 462 511
3
Speed Sensor
DRV/DMV1/ZME
EAV/DMV2
5.

Test

5.�

Switching on the EPS

Warning - Risk of injury due to escap-
ing test oil or due to parts being thrown
around!
If the hydraulic connection of the test
equipment and the Common Rail pump is
not made correctly, test oil can escape at
high pressure, or parts of the test equip-
ment can burst when starting the test. This
can lead to injury or to material damage.
¶
Before switching on, check that all the
hose lines on the test equipment and on
the Common Rail pump are connected
correctly.
¶
Do not open the anti-splash housing,
until the EPS drive has stopped.
¶
Replace any leaking and defective hose
lines.
Procedure:
1. Switch on the EPS at the main switch.
2. Start the EPS945 system software.
? "
The software performs an initialization and the
status displays light up in green.
3. Switch on the EPS converter and the test oil pump
on the EPS control unit.
4. Issue a controller enable.
" "
The EPS 815 and CRS 845 test set are ready for the
pump test.
Robert Bosch GmbH