Time Program Function; Turning Off A Hotplate Automatically; The Timer; Automatic Time Limitation - NEFF M52 Serie Instrucciones De Uso

Time program function

This function may be used in two different ways:
to automatically switch off a hotplate
■
as a timer
■

Turning off a hotplate automatically

The zone turns off automatically once the selected time has
elapsed.
Program the cooking time.
Select the power level of the desired hotplate with the
1.
appropriate control.
Press the 3 symbol. The
2.
up. ‹‹ is displayed on the time program function display.
Press the + or - symbol. The basic setting appears:
3.
+ symbol: 30 minutes.
- symbol: 10 minutes.
Press the + or - symbol until the required cooking time
4.
appears.
After a few seconds, the cooking time begins to elapse.
Note: The same cooking time can be automatically
programmed for the all the hotplates. The programmed time
passes independently for each of the hotplates.
The Basic settings chapter provides information on
automatically programming the cooking time.

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator œ / • flash alternately in the display.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
26
Ú indicator on the hotplate lights
" , ‰ symbol and the residual
Changing or cancelling the time
Press the symbol several times until the
3
required hotplate lights up. Change the cooking time using
the + or - symbols, or set to
Once the time has elapsed
The hotplate switches off. A beep sounds and in the time
program function display
‹‹
The indicator on the hotplate lights up. Pressing the
Ú
symbol turns off the indicators and stops the beeping.
Notes
If a cooking time has been programmed for various zones,
■
the time program function display always shows the time of
the last hotplate whose power or setting has been adjusted.
Cooking times can be programmed for up to 99 minutes.
■

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
The timer can be selected in two different ways:
1.
If you have selected the hotplate: press the
■
twice.
If you have not selected the hotplate: press the
■
The indicator next to the
Ú
displayed on the time program function display.
Press the + or - symbol. The basic setting appears.
2.
+ symbol: 10 minutes.
- symbol: 5 minutes.
Set the desired time using the + or - symbols.
3.
After a few seconds, the time will start to elapse.
Changing or cancelling the time
Press the symbol various times until the
3
the symbol lights up. Change the time or set to
W
the + or - symbols.
Once the time has elapsed
A warning signal sounds.
function display. After 10 seconds the indicators turn off.
Pressing the symbol turns off the indicators and stops the
3
beeping.
indicator of the
Ú
.
‹‹
appears for 10 seconds.
symbol
3
symbol lights up.
W ‹‹
indicator next to
Ú
‹‹
is displayed on the time program
‹‹
3
symbol.
3
is
with