Uline OHAUS DEFENDER 5000 Manual Del Usuario página 12

PROJECT ID
Set the Project identification.
Refer to Menu Navigation to enter settings.
SCALE ID
Set the Project identification.
Refer to Menu Navigation to enter settings.
RESET
If Reset is selected and confirmed, all the submenu
values will be set to default.
LOCK KEY CONFIGURATION
This menu is used to lock access to certain keys. When
you select ON for one selection, the associated key
pressed will be ignored.
The scale can be configured to operate in up to five
Application modes (scale can be set to have one or
more applications modes active). Press the button
Mode to select an activated application. The current
application will be shown in the upper left corner of the
home screen.
The Indicator incorporates the following applications:
WEIGHING
COUNTING
CHECK
WEIGHING/
COUNTING
WEIGHING
Use this application to determine the weight of items in
the selected unit of measure.
1. Press the
Library
Mode
button until the icon
corresponding to
Weighing is displayed
(this is the default
application). Press Tare or Zero
if necessary to begin. (See Figure 26)
PAGE 12 OF 101
OPERATION CONTINUED
APPLICATIONS
%
PERCENT
DYNAMIC
Figure 26
NOTE: Keys will not function when pressed if
Lock All Keys is selected.
NOTE: The off key will not function when
pressed if Lock Off Key is selected.
AVAILABLE SETTINGS
ITEM
(bold is the default setting)
Lock All Keys Off, On
Lock Off Key Off, On
Lock Zero Key Off, On
Lock Print Key Off, On
Lock Unit Key Off, On
Lock Soft Key Off, On
Lock Mode Key Off, On
Lock Tare Key Off, On
Lock Menu Key Off, On
Reset No/Yes
2. Place objects on the pan to display weight. When
the reading is stable, the * appears. The resulting
value is displayed in the active unit of measure.
APPLICATION SETUP
The Application can be customized for various user
preferences.
1. Press the button
corresponding to the
icon to enter
Configuration. The
Configuration screen
is now displayed.
(See Figure 27)
2. Select the list item and press the softkey
corresponding to the
as desired.
3. To return to the Application home screen, press the
softkey corresponding to the
The Weighing Configurations are defined below.
NOTE: Default settings are in bold.
ITEM AVAILABLE SETTINGS
Auto Tare On, Off
Accumulate Off, Automatic, Manual
Figure 27
icon to change the setting
icon.
COMMENTS
To enable Automatic Tare
To enable Accumulation/
Totalization
0621 IH-8105