Uline OHAUS DEFENDER 5000 Manual Del Usuario página 28

SERIAL COMMUNICATION AND PRINTER SETUP CONTINUED
MT-SICS Commands
LEVEL 0
LEVEL 1
LEVEL 2
LEVEL 3
PAGE 28 OF 101
COMMAND FUNCTION
@ Reset The scale.
I0 Inquiry of all available SICS commands.
I1 Inquiry of SICS level and SICS versions.
I2 Inquiry of scale data.
I3 Inquiry of scale software version.
I4 Inquiry of serial number.
S Send stable weight value.
SI Send weight value immediately.
SIR Send weight value repeatedly.
Z Zero the scale.
ZI Zero immediately.
D Write text into display.
DW Weight display.
SR Send and repeat stable weight value.
T Tare.
TA Tare value.
TAC Clear tare.
TI Tare immediately.
C2 Calibrate with the external calibration weight.
C3 Calibrate with the internal calibration weight.
I10 Inquire or set scale ID.
I11 Inquire of scale type.
P100 Print out on the printer.
P101 Print out stable weight value.
P102 Print out current weight value immediately.
SIRU Send weight value in the current unit immediately and repeat.
SIU Send weight value in the current unit immediately.
SNR Send stable weight value and repeat after every weight change.
SNRU Send stable weight value in the current unit and repeat after every weight change.
SRU Send weight value in the current unit and repeat.
ST After pressing the transfer key, send the stable weight value.
SU Send stable weight value in the current unit.
M01 Weighing mode.
M02 Stability setting.
M03 Autozero function.
M19 Send calibration weight.
M21 Inquire/set weight unit.
PRN Print out at every printer interface.
RST Restart.
SFIR Send weight value immediately and repeat quickly.
SIH Send weight value immediately in high resolution.
SWU Switch weight unit.
SX Send stable data record.
SXI Send data record immediately.
SXIR Send data record immediately and repeat.
U Switch weight unit.
0621 IH-8105