Carel MasterCella Hoja De Instrucciones página 17

3) Confi rm with the button;
set
4) The display shows the fi rst modifi able "C" parameter.
Accessing the confi guration parameters (type F)
1) Press the button for more than 5 sec. (in the event of alarms, fi rst mute the buzzer), the display shows the fi rst modifi able "F" param.
prg
Modifying the parameters
After having displayed the parameter, either type "C" or type "F", proceed as follows:
1) Use the or
comes on to show the category the parameter belongs to;
2) Alternatively, press the prg
3) Scroll the menu with the
Summary table of operating parameters), accompanied by the corresponding icon on the display (if present);
4) Once having reached the desired category, press
parameters are visible, pressing
5) At this point, continue to scroll the parameters or return to the "Categories" menu with the
6) Press to display the value associated with the parameter;
set
7) Increase or decrease the value with the
8) Press to temporarily save the new value and return to the display of the parameter;
set
9) Repeat the operations from point 1 or from point 2;
10) If the parameter has sub-parameters, press set to display the fi rst sub-parameter;
11) Press the or
12) Press to display the associated value;
set
13) Increase or decrease the value with the
14) Press to temporarily save the new value and return to the display of the sub-parameter code;
set
15) Press to return to the display of the parent parameter.
prg
Saving the new values assigned to the parameters
To defi nitively save the new values of the modifi ed parameters, press the
programming procedure. All the modifi cations made to the parameters, and temporarily saved to the RAM can be cancelled, returning
to "normal operation", by not pressing any button for 60 seconds, and allowing the session to expire by timeout. If power is disconnected
from the instrument before pressing the
Direct access to the parameters by selecting the category
The confi guration parameters can be accessed, as well as already described above, also by the category (see the icons and the abbre-
viations in the table below), according to the list on the display relating to the name and the corresponding icon. To directly access the
selection of the parameters grouped by category, press
Category
Probe parameters
Control parameters
Compressor parameters
Defrost parameters
Alarm parameters
Fan parameters
Confi guration parameters
HACCP parameters
RTC parameters
button to scroll the parameters until reaching the one to be modifi ed; when scrolling, an icon on the display
button to display a menu for quick access to the family of parameters to be modifi ed;
and buttons, the display shows the codes of the various categories of parameters (see the
set
will have no effect);
set
or
button to display all the sub-parameters;
or
button, all the changes made to the parameters and temporarily saved will be lost.
prg
prg
Parameters
/
r
c
d
A
F
H confi guration
H HACCP
rtc
to directly access the fi rst parameter in the chosen category (if none of these
button respectively;
button respectively;
prg button for more than 5 seconds, thus exiting the parameter
, / , and to modify the parameter press
Text
'Pro'
'CtL'
'CMP'
'dEF'
'ALM'
'FAn'
'CnF'
'HcP'
'rtc'
17
+050004105 rel. 0.0 del 27.07.05 - Preliminary version
button;
prg
,
set
Icon
/ ...
Tab. 3.2.2