Setup And Installation; Rack-Mount Setup - Eaton Powerware 9125 Guia De Instalacion

4.

Setup and Installation

The P30 UPS is designed for flexible configurations and can be installed
in a rack, as a standalone cabinet, or in a tower configuration.
NOTE
to "Power Connections and Startup" on page 20. If you are installing the UPS in an IBM
iSeries (0550 or 0551 types) or pSeries (7014 type) rack, continue to the following section,
"Rack-Mount Setup." If you have another type of rack, contact your service representative
(see page 49).
NOTE
Setup" on page 10 to begin the UPS setup.

Rack-Mount Setup

The UPS can be installed in 19-inch racks and needs only 2U of valuable
rack space.
NOTE Mounting rails are required for each individual cabinet.
NOTE The UPS and any optional cabinets MUST be installed at the bottom of the rack. If
placed in a rack with existing equipment, the rack must be reconfigured to allow the UPS
installation at the bottom of the rack.
Each UPS and EBM requires one (1) of each item in the following list:
S
S
S
S
®
EATON Powerware
Reinstall the UPS front cover (see Figure 3).
Figure 3. Reinstalling the Front Cover
For UPS rack installations:
For UPS standalone cabinet or tower installations:
Left rail
Right rail
Rail hardware kit
Rack mounting bracket kit
9125 (9910-P30) UPS Installation Guide for IBM
If the UPS is pre-installed in an IBM rack, continue
Continue to "Tower
® S
Applications 164201636 Rev A
INSTALLATION
5