Kit Assembly - Metra 99-3019B Manual De Instrucciones

ISO DIN radio provision with pocket
1. Secure the pocket to the radio
brackets using the (4) #8 x 3/8"
Phillips screws provided. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Secure the radio to the radio
brackets using the screws supplied
with the radio. (Figure A)
4. Slide the radio/pocket/bracket/
assembly in between the radio
trim panel and the radio housing
and secure with the (6) #8 x 3/8"
Phillips screws provided. (Figure B)

Kit Assembly

5. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
6. Reassemble the dash in reverse
order of disassembly.
99-3019B
(Figure A)
(Figure B)
3