Publicidad
PH10 PLUS installation and user's guide
http://www.renishaw.com
PH10 connection of probes and extensions
PH10T PLUS M8 connection
PH10T PLUS is designed to carry Renishaw probes and extensions with an M8 screw thread. Probes and extensions are screwed into
the probe head's bush and tightened with the appropriate spanner.
CAUTION: Never use anything other than the Renishaw spanner provided and do not apply excessive force.
PH10M PLUS and PH10MQ PLUS autojoint connection
PH10M PLUS and PH10MQ PLUS heads use a Renishaw autojoint which is a highly repeatable kinematic joint, one half is integral to the
head. The other half forms part of the adaptor, extension bar or probe.
Locking and unlocking the autojoint is carried out either manually, using the autojoint key, or automatically using the Renishaw autochange
rack systems (ACR1 or ACR3). In both cases, the connection's repeatability eliminates the need for probe requalification after exchange.
If an extension bar, adaptor or probe needs to be attached to the head manually, ensure that the location dots shown in the image below
are aligned.
Issued 01 2013
Page 18 of 48
Publicidad
