Publicidad
PH10 PLUS installation and user's guide
http://www.renishaw.com
Key
Description
1
9-way D-type plug for PICS output
2
9-way D-type connector to HCU1
3
25-way D-type plug RS232 communications connector to CMM computer
4
USB type "B" socket
5
PHC10-3 configuration switches
6
15-way D-type connector to probe head
7
7-pin DIN raw probe connector to probe interface or multiwire input for internal interfaces
8
DC power jack
9
Equipment bond point
10
Reset button
Refer to the PHC10-3 PLUS installation guide (part number H-1000-0077) for further detail.
PHC10-3 PLUS LED description
Name
POWER
STOP
HEAD READY
HEAD ACTIVE
DATUM ERROR
OBSTRUCT ERROR
OVERLOAD ERROR
TP7
TP200
STD
SEATED
DAMPED
NOTE: The probe reset button on the front of PHC10-3 PLUS only functions if a probe interface card is installed within the unit.
Colour
Function
Green
Power on when lit
Red
PHC10-3 PLUS asserting PICS STOP when lit
PI 200 asserting PICS STOP when flashing
Green
Head ready for use when lit
Yellow
Head indexing when lit
Red
Head datum error when lit
Red
Head obstruct error when lit, non PLUS interface fitted
Red
Head overload error when lit
Green
TP7 detected when lit
Green
TP200 detected when lit
Green
TP2 / TP20 / TP6 detected when lit
Green
Probe seated when lit
Yellow
Probe damped when lit
Issued 01 2013
Page 23 of 48
Publicidad
