General Safety Information - MS Schippers SmartScan Manual Del Usuario

3. Do not drop or hit the device during use.
4. Wait at least 2 to 3 minutes after shutdown before restarting the device.
5. In case of abnormality during ascan, immediately stop and shut down the device.
6. Do not put excessive upward or downward pressure on the device during use to prevent possible
damage to the sound head oiler.
7. Always check the battery level and charge the battery in a timely manner when necessary.
8. The device can be used during charging, and extra attention should be paid to safety.
After Operation
1. Cut off the power.
2. Check whether the waterproof rubber plug of the charging base is properly closed before washing
the device.
3. Gently wipe the probe oiler with a piece of wet soft cloth. Try to reduce friction damage on the
sound head oiler.

General Safety Information

■ The following safety measures must be taken to ensure the safety of the operator and patient and the
reliability of the device:
1. The device should be used by or under the direction of a qualified operator.
2. Do not change the parameters of the device. If change of parameters is required, please contact a local
dealer or SONOWIN.
3. The device is tuned to best performance before it's delivered. Use it as instructed by the Manual. Do not
adjust any preset control or switch.
4. In case of failure of the device, immediately shut down the device and contact a local dealer or
SONOWIN.
5. To upload the product information to the internet, please contact a local dealer or SONOWIN for
value-added service.
6. Operating, Storage and Transport Environment of the Device:
● Avoid violent vibration under normal operation and keep the temperature, humidity and power supply
within the following range:
1) AmbientTemperature Range: -20
2) Relative Humidity Range: 30%-80%
3) Power Supply Range: a.c. 100V-240V, 50/60Hz
● Avoid exposure to the rain or snow and mechanical collision during transport. Do not load or transport
the device with corrosive substances.
● Since the host contains a built-in battery, the device should be stored in a dry place:
1) AmbientTemperature: -20oC-+50 oC (for less than 1 month of storage)
AmbientTemperature: -20oC-+45 oC (for 1 to3 months of storage)
AmbientTemperature: -20oC-+20oC (for less than 1 year of storage)
2) Relative Humidity: Less than 80% (20oC)
3) The indoor storage environment should be protectedfrom strong sunlight and other corrosive gasses,
and well-ventilated.
7. To reduce the risks during use, please use the power cordthat comes with the device and standard grounded
grid power supply.
8. SONOWIN will assume no liability for risks arising from unauthorized dismantling or modification of the
device by the user.
9. Turn off the power if the device is not to be used for a long period of time.
10. Do not press the probe too hard on the patient during the diagnosis to avoidunnecessary injury.
EN - MS Smartscan Manual
4
o C-+60 o C
4
37