Power On The Smartscan; Successful Connection; Unsuccessful Connection - MS Schippers SmartScan Manual Del Usuario

2.2.4 Power on the SmartScan

---- Press and hold the Main Key for 7 seconds until the indicator turns blue to
power on the SmartScan;
---- The indicator will then flicker at a slow rate. Immediately the SmartScan will
automatically search for a matching WIFI signal pathway.
---- Check the bottom of the screen on the smart device.

2.2.5 Successful Connection

---- When "Connected" appears on the bottom of the operating interface, it means that the smart device has
been connected with SmartScan.
---- Press the Main Key to enterthe real-time ultrasound scan mode.

2.2.6 Unsuccessful Connection

---- If the following prompt pops up on the operating interface, it means that the smart device
hasn't been connected with SmartScan. Reboot the SmartScan as instructed and click Retry until
it's connected.
---- If the same prompt appears on the operating interface after Retry several times, it indicates
that the smart device is not installation-compatibleand the SmartScan App is not properly
installed.
EN - MS Smartscan Manual
ID:
Depth: 160 mm
Gain: 100 dB
Connected
connected
15
48