Power Charging - MS Schippers SmartScan Manual Del Usuario

6
The battery level icon of SmartScan can be found inthe lower right corner of the operating interface of the
smart device. When the battery is fully charged, there will be 3 bars.
Always note the change of the icon. Charge the SmartScan when there is only one bar left.
The SmartScan battery is built-in. Includedwith the SmartScan is a battery adapter with DC031A port.
Technical Parameters of Adapter: 4.2V, 2A, VAC100-240, 50/60Hz
The battery level when delivered from the factory is 10% only. Make sure that the battery is fully charged
before first use.
At the end of the host (probe) is a transparent waterproof rubber cap. Protected by the cap is the DC-031A
charging port. Open the cap and insert the charging cord. The indicator will turn red, indicating that the battery
is being charged. When the indicator turns green, the battery will be fully charged and the charger can be
EN - MS Smartscan Manual

Power Charging

Transparent Waterproof
Silica Gel Cap
(Charging Port)
31
Host
Battery
64