Software; Network Safety; System Requirements; Technical Specifications - MS Schippers SmartScan Manual Del Usuario

1.6 Software

 The icon of the SmartScan App is:
 If a smart device is presented during the purchase, the SmartScan App will be properly installed and ready
to use after boot;
 If no smart device is presented during the purchase, the SmartScan App should be provided to the buyer or
a local dealer for installation as required.
 The current version of the SmartScan App is MYJC-V1.0. Please contact
Schippers (http://www.schippers.eu)

Network Safety

To ensure the stable and safe connection between a smart device and SmartScan, the SmartScan App adopts the
self-configured WiFi connection mode for automatic encryption and connection.
In places with concentrated WiFi signals, the self-configured WiFi signals will be inevitably affected and the
SmartScan may experience frame rate lowering. There is no need to worry about this normal phenomenon.
Once the WiFi is disconnected, the smart system will automatically shut down after a period of continuous
monitoring to enhance the working hours of the battery.

System Requirements

The smart device on which the SmartScan App runs must meet the following minimum requirements:

Technical Specifications:

● SupportsBLE (Bluetooth) v4.0+
● Supports WIFI 802.11n and WIFI direct use
● At least s 16G hard disk
● At least 2G RAM
Operating System:
● Android System 6.5 (Only compatible with systems below 6.5)
Processor:
● Dual core CPU
● ARM-based CPU architecture (Android device)
EN - MS Smartscan Manual
for software updating.
Suggestion:
Do not use the device in places with concentrated WiFi signals.
9
local exclusive distributor MS
42