Miltenyi Biotec gentleMACS Manual Del Usuario página 70

2. Press OK to confirm a value or Exit to cancel.
Parameters for an individual step will be displayed in an abbreviated form. In this example, spin –2,000 rpm,
1'' indicates a counter-clockwise spin of 2,000 rpm for 1 second.
4
3. Press Add to insert the next command or Save to name and store the program for future use (refer to step 11.).
In this example, a second spin command is added, namely a clockwise spin at 2,000 rpm for 10 seconds.
Note: Loop commands enable the repetition of program steps. The iterations will only include the steps
between a loop and end loop command. In this example, the two spin commands shall be repeated three
times.
4. Highlight the first command and press Add to select the next command. Select loop to mark the beginning of
an iteration. Enter the number of iterative cycles. In this example, 3 cycles are chosen.
68