Miltenyi Biotec gentleMACS Manual Del Usuario página 71

5. Click OK to confirm the selection. The command loop and the number of cycles are displayed as a new step.
6. Highlight the end command and press Add. Select end loop to close the iterative cycle.
7. Press OK to confirm.
8. Highlight the first command and press Add to insert another command. Select ramp to reach a certain speed
in a defined time.
9. Enter speed and time. Press OK to confirm the values. In this example, a ramp of 2,000 rpm in 10 seconds has
been added.
10. Highlight the end command and press Add. Select temp and ON from the pop-up screen to mark the
beginning of the heating period. Press OK to save the value.
4
69