Installing The Main Unit Inside The Boot; Using Tapping Screws - Pioneer AVIC-505 Manual De Instalación

Installation
Installing the main unit inside the boot, on the floor under a seat, etc.,

using tapping screws

1. Fit the mounting brackets to the sides of the main unit.
Use the following holes on
the mounting brackets.
2. Fix to the floor with tapping screws.
Floor
CAUTION
• Before drilling any mounting holes, confirm that the screws will not interfere
with any of the vehicle's operating systems (such as the fuel line, brake lines,
electrical wiring, etc.).
15
Mounting bracket
Screws (5 × 8 mm)
Tapping screws
(6 × 16 mm)
Drill 4 to 4.5 mm
diameter holes.