Canon FAX-JX500 Guia Del Usuario página 51

7
Press [Stop].
Setting ends and the fax returns to standby mode.
Setting PIN ENTRY
If you set <PIN ENTRY> setting to <ON>, you must enter a password to use the forwarding
feature (see page 47).
1
Follow steps 1 to 4 on page 46.
2
Use [ ] or [ ] to select <ON>, then press [Start]. The LCD displays <FWD TEL
NUMBER>.
3
Use [ ] or [ ] to select <PIN ENTRY>, then press [Start]. The LCD displays
<ON>.
4
Use [ ] or [ ] to select <ON>, then press [Start].
5
Press [Stop].
Setting ends and the fax returns to standby mode.
When a Forwarded Call is Received
When <FWD SETTINGS> is set to <ON>, telephone messages recorded when the fax is set to TAM
MODE will be automatically forwarded to a registered forwarding number.
1
A call is received at the forwarding number.
2
When you answer the phone you will hear your forwarding message.
3
Press [#] while the forwarding message is playing.
If you have not set a forwarding message, press [#] when you hear the tone.
4
Enter your password when you hear the beeps.
When <PIN ENTRY> is set to <OFF> (see page 47), step 4 is not required.
If you enter an invalid password, you will hear an error tone. If you enter two invalid
passwords consecutively, the call will be disconnected.
5
Any new telephone messages will be played.
6
When playback ends, it will be possible to use the remote control features.
For the remote control features, see page 43.
7
Hang up the Handset when you have finished.
Using TAM Mode (FAX-JX500/JX300 only) 47