Canon FAX-JX500 Guia Del Usuario página 59

Coded Speed Dialing List
Lists the numbers and names registered under coded speed dialing codes.
User Data List
Lists the current settings of the fax and the registered sender information.
List of Documents in Memory
Lists the documents currently stored in the fax's memory (see page 36).
TX (Transmission) Report
Normally the fax does not print an activity report for transmitting, but you can set the fax to print
an activity report every time you send a document. See <TX REPORT> on page 50.
You can set the fax to print an activity report only when an error occurs during transmitting. See
<TX REPORT> on page 50.
RX (Reception) Report
Normally the fax does not print an activity report for receiving, but you can set the fax to print an
activity report every time you receive a document. See <RX REPORT> on page 50.
You can set the fax to print an activity report only when an error occurs during receiving. See
<RX REPORT> on page 50.
Multi TX (Transmission) Report
Lists the result of a sequential broadcasting.
If you set the fax to print a <TX REPORT> and then use sequential broadcasting, a MULTI TX
REPORT will be printed instead of a TX (Transmission) REPORT. See <TX REPORT> on
page 50.
Note
FAX-JX500/JX300 models:
Faxes or messages stored in the memory are backed up automatically if the power is tuned off or
fails. If however, the data cannot be retrieved when the power is tuned on again, a memory clear
report is printed automatically.
FAX-JX200/JX201 models:
A memory clear report is printed automatically when power is restored after a power failure. See
"Memory Clear Report" on page 74.
Settings and Activity Reports 55