Comet BPS TANDEM Instrucciones Para El Ensamblaje Y El Mantenimiento página 26

from wrong manoeuvres with the jet of fluid under pressure.
• WARNING. Do not use the pump or the machine in which it is integrated near people if these are not
wearing personal protective equipment.
• WARNING. Do not direct high-pressure jets against yourself or other people to clean clothes or footwear.
• WARNING. High-pressure jets can be hazardous if incorrectly used. High-pressure jets must not be
directed against people, energized electrical appliances or the pump itself or the machine in which it is
integrated.
• Never run the machine in which the pump is integrated in closed premises, if this is driven by an internal
combustion engine.
• WARNING. Explosion risk - Do not spray inflammable liquids.
• Keep clear of moving parts of the pump and of the machine in which it is integrated, even if these are
adequately protected.
• Do not remove the guards of the moving parts.
• In applications in which the pump is driven by a cardan shaft, avoid any pushing on the pump shaft due
to excessive steering radii, not compatible with the type of cardan used.
• Do not touch pipes containing liquids under pressure.
• Do not perform maintenance operations on the pump and on the machine in which it is integrated if
this is operating.
• Read the "INTENDED USE" paragraph carefully.
• Do not modify in any way the installation conditions of the pump. In particular, do not modify the
fastening, the hydraulic connections and the guards.
• Do not open any taps on the pump unless these are connected to an accessory that prevents the accidental
escape of the pumped liquid.
• Do not deactivate or tamper with the controls and the safety devices and the pressure unloader/regulation
valve.
• The connection of the machine in which the pump is integrated to the power mains must be made by
a Professional Electrician in accordance with the regulations applicable in the country of use.
• During operation:
- always keep an eye on the pump and the machine in which it is integrated and out of the reach of
children; in particular, be very careful when using near nurseries, clinics and old-people's homes, in
case of children, elderly people or disabled people without supervision;
- do not direct high-pressure jets against materials containing asbestos or other substances harmful for
the health;
- do not cover the pump and the machine in which it is integrated and do not place them where ventilation
is prevented (remember this above all when using the machine in closed environments);
- grip any sprinkler lance used firmly because when the lever is operated, the high pressure jet causes a
strong reaction;
- when not in operation and before doing any jobs, perform the operations described in the "STOP"
paragraph;
- operating pressure must never exceed the maximum value set for the pump, as shown in the technical
data plate;
- use adequate personal protective equipment to safeguard against noise emissions (e.g., ear muffs).
• Read the instructions and warnings on the label of chemicals to be distributed by the pump to take the
appropriate steps in order to avoid danger for the operator or for the environment.
• Store all chemicals in a safe place out of children's reach.
• Should any chemicals come into contact with your eyes, wash immediately with water. Contact a doctor
without delay and remember to take the container of chemicals with you.
• If any chemicals are swallowed, do not provoke vomiting. Contact a doctor without delay and remember
to take the container of chemicals with you.
Perform the steps relating to the high-pressure operation indicated in the manual relating to the
machine in which the pump is integrated; unless otherwise indicated, in relation to the pump,
the following should be remembered.
For the following points, please also refer to the documentation which is provided with the control unit
a) Set the delivery pressure to zero on the control unit so that it enters its "bypass" status.
b) Start up the pump so that it can prime.
c) Set the control unit to its "pressure" position.
26