Comet BPS TANDEM Instrucciones Para El Ensamblaje Y El Mantenimiento página 32

Make sure the following always accompany the pump:
• instruction manual - general section;
• instruction manual - specific section for the series;
• declaration of integration;
• warranty certificate;
• assistance centre booklet.
In case of any problems, contact the Dealer or an authorized after-sales centre.
WARNING
• The Skilled Technician must follow the installation instructions in this manual; in particular the
specifications of the motor unit (e.g., electric or combustion motor) must be in conformity with the
performance and construction features of the pump (power, rotation speed, flanging, etc.) indicated in
the Manufacturer's technical documentation.
• The machine in which the pump is integrated must be made so as to ensure conformity with the safety
requirements established by European directives. This fact is guaranteed by
Declaration of Conformity of the Manufacturer of the machine in which the pump is integrated.
• The pump must be installed and made to operate horizontally.
• The pump must be stably fastened.
• The pump, being of the positive-displacement type, must always be equipped with a pressure
unloader/regulation valve and with a safety valve.
WARNING
• Adequately protect the moving parts with suitable protections. Special focus must be placed on pulley
applications and the PTO of the tractor.
• The pump must operate at a rotation speed within the window indicated in the specific manual of
the series (→MS).
• The pump must be firmly fastened by means of the feet on a stable base or, when indicated, connected
to the motor unit according to the provisions of the specific manual of the series (→MS).
• In the case of through shaft, do not exceed the max available power ratings indicated in the specific
manual of the series (→MS).
The numerous available applications are shown in the specific manual of the series (→MS).
CAUTION
• Always contact the Dealer or Manufacturer to determine the correct application.
• Pump applications must be performed in a good mechanical workmanlike manner.
The Manufacturer's Technical Assistance Service is at the installer's disposal to provide all necessary
details.
• The pump must be installed in line with the mechanical drive parts (multipliers, reduction units, etc.).
Follow the connection instructions already indicated in the "HYDRAULIC CONNECTIONS" paragraph
of part one.
In particular as regards sizing the intake circuit refer to the indications of the specific manual of the
series (→MS).
32
INSTALLATION
APPLICATIONS
HYDRAULIC CONNECTIONS
marking and by the