Removing The Appliance From Its Packing Materials; Standard Accessories - Comet BPS TANDEM Instrucciones Para El Ensamblaje Y El Mantenimiento

PROBLEMS
Too much noise (associated
with a drop in oil level only
in the case of diaphragm
pumps)..
Excessive consumption of oil
and/or oil is whitish colour
(presence of water in oil)
(for diaphragm pumps only).
WARNING
• This part of the manual is only for use by Skilled Technicians and is not meant to be used by the end
user of the pump.

REMOVING THE APPLIANCE FROM ITS PACKING MATERIALS

WARNING
• Protective gloves and glasses must be worn when removing the appliance from the packing materials
to prevent injury to the hands and eyes.
• The packing materials (plastic bags, staples etc.) must not be left in reach of children, as they are
potentially dangerous.
• The packing materials must be disposed of according to current regulations in the country where the
pump is installed.
In particular, plastic bags and packaging must never be abandoned, as they are harmful to the
environment.
• After removing the appliance from the packing materials, check that no parts are missing and check
that the identifi cation label is present and is legible.
In case of doubt, do not use the pump under any circumstance and contact the dealer.
WARNING
• The instruction manuals, the assistance centre booklet and the warranty certificate must always
accompany the pump and be made available to the end user.
CAUSES
Suction circuit with choke points.
Water supply temperature too high.
Rupture of one or more diaphragms Refer to instructions in section
PART TWO
(only for use by Skilled Technicians)

STANDARD ACCESSORIES

SOLUTIONS
Check the suction circuit (especially
make sure the suction filter is clean).
Keep to the instructions indicated in the
"INTENDED USE" paragraph and in the
specific manual of the series (→MS).
"DIAPHRAGM RUPTURE".
EN
31