Sencotel 121c Manual De Empleo página 57

When the icon above is shown at the display it is necessary to
refill with product the tank inside the fridge
It is advisable to refill always the tank when it
is required in order to avoid its emptying, as
it may involve a loading with an excessive
amount of air inside the cylinder modifying
the ice consistency.
Once the tank refill has been made proceed as follows in order
to remove the message from the display:
-Activate the production function of the machine
-open the fridge door
-press the selection key
the message rSF will appear in the dislpay, that means that
the tank has been refilled.
Everytime the fridge tank is refilled, before the
message appears, it is necessary to cancell it as
mentioned above in order to comunicate the
machine that the tank has been refilled
The tank refill request is shown according to a deal counting in
production mode.
The following procedure shows how to disable this function or
how to change the number of deals reached to show the
message at the display.
- Select STOP mode
- Push at once STOP and SELECTION
message is shown at the display.
- Push more times until the tank refill message is shown
- By means of SELECTION key
function or select the number of deals desired after which the
message will appear at the display.
- The machine will go back in STOP mode
- Open fridge door message
This message indicates that the fridge door is open. The
message desappears by closing the door.
13
keys until HOT
set 0 to disable the
automatically.
- Fridge defrost requirement
The message above appears at the dislpay when the fridge is
investing too much time in reaching the operation temperature.
The reason may be an excessive ice accumulation on the
evaporator surface. In this case a manual defrost is advised
(see chap 6.6)
Press the selection key in order to remove the message
from the display.
- Wash request message
This message means the need to clean the machine. If the
massage appears in the display while the production function,
it doesn´t stop and it is possible to ignore the message by
pressing the selection key
wash message is shown it will not be possible to activate the
production nor maintenance functions. It only will be possible
to activate the clean function. To restart the operation mode it
is necessary to clean the machine (see cap. 7)
The following procedure shows how to disable this function or
how to change the number of days reached to show the
message at the display.
- Select STOP mode
- Push at once STOP and SELECTION
message is shown at the display.
- Push more times until the wash message is shown
- By means of SELECTION key
function or select the number of days desired after which the
message will appear at the display.
- The machine will go back in STOP mode
The machine cleaning and sanitization must
be made necessarily 72 hours after the
introduction of the product.
SL320003270 Ed 03_EN
. If the machine is in stop and the
keys until HOT
set 0 to disable the
automatically.