Cleaning And Sanitizing Of Cylinder; Assembly Of Product Suction Tube - Sencotel 121c Manual De Empleo

7.1.6 Cleaning and sanitizing of cylinder

While the disassembled components are soaking in the
disinfectant solution, clean and sanitize the churning cylinder
as follows:
- Remove any product residue from the churning cylinder.
- Wash the cylinder using a sponge soaked with drinking
water.
- With the supplied brush clean the hole between the fridge
and the cylinder and the cylinder product loss groove.
- Clean all parts of the cylinder using a sponge wet with
disinfectant solution.
- Clean the hole between the fridge and the cylinder with the
brush soaked with disinfectant solution.
- Let the disinfectant solution work for 10/15 min.
- Remove the disinfectant from the cylinder and the hole
between the fridge and the cylinder with care, using a sponge
soaked with water.
SL320003270 Ed 03_EN

7.1.7 Assembly of product suction tube

To assemble the product suction tube, proceed as follows:
- Assemble the non-return valve (D) to the inlet pipe (C), then
assembly the joint (C1) to the inlet pipe (C) as it is shown in
the figure below.
It is advisable to use the O-ring extractor in order to assemble
the non return valve (D) easier.
Check the correct assembly of the non return valve (D) and the
joint.
-Lubricate the inlet pipe joint (C1) with the supplied lubricant
(C), introduce it into the hole between the fridge and the
cylinder and block it with its subjection (A).
- assemble the pump body again: check the fitness between
attachments, place the pump in its support and turn it
clockwise to block it.
18