Optional Accessories; Protecting The Environment - DeWalt DW712 Traducido De Las Instrucciones Originales

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: To reduce the risk of injury, regularly clean
the table top.
WARNING: To reduce the risk of injury, regularly clean
the dust collection system.
CLEANING AND MAINTAINING THE KERF PLATE (FIG. U)
Regularly clean the area below the kerf plate.If the kerf plate is worn it
must be replaced.
• Remove the screws (67) holding the kerf plate (31).
• Remove the kerf plate and clean the area below.
• Re-install the parts of the kerf plate and the screws.
• Tighten the screws hand-tight.
• To adjust the kerf plate, proceed as follows:
• Pull down the head until the blade just enters the saw kerf.
• Adjust each part of the kerf plate to fit closely to the teeth of the
blade.
• Tighten the screws.

Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
SAW BLADES
ALWAYS use 216 mm saw blades with 30 mm arbour holes. Blade
speed rating must be at least 5500 RPM. Never use a smaller or
greater blade diameter. It will not be guarded properly.
BLADE DESCRIPTIONS
APPLICATION
Construction Saw Blades (for all purpose cutting)
General Purpose
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts
Consult your dealer for further information on the appropriate
accessories.

Protecting the Environment

Separate collection. Products and batteries marked with
this symbol must not be disposed of with normal household
waste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle electrical
products and batteries according to local provisions. Further information
is available at www.2helpU.com.
WALT, recommended
e
DIAMETER TEETH
216 mm 48
216 mm 60
E NG L I SH
35