FujiFilm SonoSite SII Guia Del Usuario página 7

To calculate MV or AV area
1 On a frozen 2D image, tap Calcs.
2 In the calculations menu, tap Area.
3 In the Area menu, select MV or AV.
4 If you are using the touchscreen, lift your finger from the screen momentarily to activate the trace. If you
are using the touchpad, tap
The trace feature becomes active.
5 Using the touchpad or the touchscreen, trace the desired area.
To make a correction, tap Undo, or tap the measurement name to restart the measurement.
When using the touchpad to trace a shape, be careful not to touch
WARNING
you are finished with the trace. Doing so may complete the trace prematurely,
causing an incorrect measurement and delay of care.
6 When you are done, tap Set. The two ends of the trace are joined automatically.
7 Tap Save Calc.
8 To save a picture of the finished calculation, tap
9 Tap Back to exit the calculation.
To calculate LV mass
1 On a frozen 2D image, tap Calcs.
2 In the calculations menu, tap LV mass.
3 Do the following for these cardiac measurements, EPI and Endo:
a Select the measurement name from the LV mass menu.
b Using the touchpad or the touchscreen, position the caliper where you want to begin the trace.
c If you are using the touchscreen, lift your finger from the screen momentarily to activate the trace. If
you are using the touchpad, tap
To make a correction, tap Undo, or tap the measurement name to restart the measurement.
d Using the touchpad or the touchscreen, trace the desired area, and then tap Set.
When using the touchpad to trace a shape, be careful not to touch
WARNING
you are finished with the trace. Doing so may complete the trace prematurely,
causing an incorrect measurement and delay of care.
User Guide Errata
to set the position.
.
to activate the trace.
until
until
5