Kit Assembly - Metra 95-8225G Instrucciones De Instalación

Double DIN radio provision
1. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
2. Secure the double DIN trim plate into
the factory A/C vent panel using the
factory hardware. (Figure A)
3. Attach the factory radio brackets to
the double DIN radio with the screws
supplied with the radio. (Figure B)
4. Secure the aftermarket radio into the
dash using (4)10 mm bolts. (Figure C)
5. Snap the factory vent panel/double DIN
trim plate over radio. (Figure D)
6. Reassemble the remaining radio
and dash assemblies in reverse order
of disassembly.
95-8225G

Kit Assembly

Rear view - A/C vent panel
REAR VIEW - A/C VENT PANEL
(Figure A)
(Figure B)
(Figure C)
(Figure D)
3