SATA AE1032H Manual De Instrucciones página 77

Desmontadora automática de neumáticos
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 305
AE1032H
EN
DE
RU
KO
PT
JA
ES
• Rotate clockwise so that the gripper is at 6 o'clock (sensor at 10 o'clock).
• The bead is now engaged.
• Engage the bead with the demounting head.
• Rotate clockwise to demount the tyre, with the bead breaker disc in the down position.
• Remove the gripper.
• Now demount the tyre underside, taking care not to damage the sensor.
Tyre mounting
• Refit the valve sensor (if removed).
• Lubricate both tyre beads.
• Place the sensor at 5 or 6 o'clock.
• Set the tyre at an angle of about 45 degrees
• Turn the tyre so that it touches the mounting head and starts to be mounted on the rim.
• Rotate the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock.
• Lower the bead breaker to allow a bead piesser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of the tyre inside the open centre
during rotation.
• Rotate the tyre and make the necessary adjustments until the upper bead has been mounted.
• It may be useful to help the operation with a second Run- Flat gripper and/or the bead presser accessory, if available.
• Using the bead breaker disc, remove the Run-Flat grippers used.
• Connect the inflation line to the valve for bead insertion.
77
- 03 -

Publicidad

Tabla de contenido
loading

Tabla de contenido