Step 10: Closing The Computer - IBM OPTIONS SCSI Manual Del Usuario

1. Locate a free-device connector on the SCSI cable. One end of the SCSI cable
is connected to the SCSI adapter, and the other end has connectors for
attaching multiple SCSI devices.
2. Attach an available connector on the SCSI cable to the connector on the
hard disk drive, as shown in the illustration.
If you are connecting your new drive to a SCSI adapter that has 68-pin
D-shell connectors, the connector is narrower at the top and fits only one
way.
Attention: Do not force the power connector into the drive. If the
connector does not seat using reasonable pressure, turn it around and try
again.
3. Find an unattached power connector coming from the computer power
supply, and attach it to the four-pin dc power connector on the back of the
drive, as shown in the illustration.
If all power cables are in use, purchase a dc Y-connector (available at most
electronics stores), and split a connection to make room for more devices.

Step 10: Closing the computer

To complete the hardware section of the drive installation, do the following:
1. Be sure that the hard disk drive is securely mounted and the connectors are
firmly attached.
2. Be sure that the cables do not interfere with the computer cover and do not
block the power-supply fan blades or airflow paths.
3. Reinstall the computer cover.
4. Reconnect all devices.
5. Check your keyboard, mouse, and monitor for loose connections.
Part 1: Installation and user's guide
1-11