Pan Bars; Fitting A Camera - Vinten Vector 750 Manual Del Usuario

English
WARNING!
The head is mounted on a tripod, pedestal or suitable firm surface using the four fixing bolts and washers.
The four bolt fixing holes (19) on the underside of the head are easily located using the bolt hole position
indicators (20). Tighten the bolts with the spanner provided.
After mounting the head, ensure it is level using the level bubble (8), which may be may be illuminated by
pressing the switch (7). The light will go out after approximately 15-seconds.

Pan bars

Fit the pan bars to the head and adjust the position of each one before tightening the clamp (10) on the
mounting (18). Adjust the length of the telescopic pan bars.

Fitting a camera

WARNING!
To fit a camera, proceed as follows:
Lower the mounting to a convenient working height.
If not already fitted, install the wedge adaptor (1) in the middle position on the slide plate (14) (see
Repositioning the wedge adaptor on page 13).
Attach the wedge to the camera/lens.
Ensure that the centre lock (16) is engaged (see Locking the platform on page 10).
Apply the pan brake (4) (see Pan and tilt brakes on page 10)
Slide the wedge adaptor operating lever (2) forward (parallel to the wedge) about 6 mm (1/4 in.)
against spring tension. Pull the operating lever out, away from the body of the wedge adaptor, as
far as it will go.
Insert the camera wedge into the wedge adaptor and push it forward into full engagement. Push in
the operating lever (1) until it lies parallel with the wedge adaptor body. During this operation
resistance of the spring-loaded over-centre mechanism will be felt. As the lever reaches the end
of its travel it will slide back (parallel to the wedge) to the locked position.
Confirm that the lever is in the locked position. This is indicated by coloured bands above the lever.
When the green band only is visible, the lever is locked. If any of the red band can be seen, the
lever is not locked.
Install the remainder of the payload (lens, zoom and focus controls, viewfinder, prompter etc.).
8
1. Only mount this product on equipment designed to support a
minimum of 95 kg (109 lbs.).
2. Before installing the head, hold a fixing bolt in position and check
that the threaded end does not project more than 20 mm (3/4 in.)
above the mounting face.
1. Do NOT rely on the tilt brake when changing the payload. Always
engage the centre lock.
2. Ensure that the weight and C of G height of the total payload is
within the range for which the head is designed: up to 75 kg (167.3 lb)
with C of G height from 80 mm (3 in) to 250 mm (10 in).
.