Auxiliary Functions; Safety Measures - Fagor ADVANCE AG-061 Manual De Instalación, Uso Y Mantenimiento

EN

AUXILIARY FUNCTIONS

4.1.7
Special options selector button.
14
15.1. Cool down display.
15.2. Humidifier display.
15.3. Descaling display.
Burner blocked display (GAS models).
15.4.
COOL DOWN
4.1.7.1
To cool the cooking chamber, proceed as follows:
When the door is closed and the oven temperature is more than 45 °C, press the special functions
button (14) (COOL DOWN). All the special options light up. Use the general options knob (18) to
select the option COOL DOWN (15.1). Confirm the option by pressing the special options button (14)
or the general options knob (18).
Next open the door.
The fan starts. When the chamber temperature reaches 45 °C, the fan stops automatically.
The cooling cycle can be stopped by pressing button 19 again or by closing the door, and the cool
down indicator will go out.
Warning: Do not cool the oven by directly applying cold water in the tub.
SAFETY MEASURES: The fan cover and the tray guides must be correctly fastened in
place during this cycle.
The cooking chamber must not be cooled with cold water.
HUMIDIFIER BUTTON
4.1.7.2
To activate the humidifier, press the special options button (14). All the special options light up. Use
the general options knob (18) to select the option HUMIDIFIER BUTTON (15.2). Confirm the option
by pressing the special options button (14) or the general options knob (18).
The moisture inlet only operates when the door is closed and the oven is in Start mode (in Stop
mode the signal is ignored).
Bakery products rise very well using this function thanks to the rapid entrance of moisture.
Soft shine to baked products.
It should be used for short periods of time.
DESCALING DISPLAY
4.1.7.3
When the oven automatically detects excess limescale in the pipes, a message is sent via the display
(general information text 3) informing of the need to descale.
The text DESCALING flashes on the display. The speed of the flash increases with the need for
decaling, and when descaling is obligatory the message is permanently lit (at this point the oven only
operates in convection mode).
The descaling function is performed by the SAT. Therefore, if the oven requires
descaling please contact the maintenance technician.
To descale, enter the function by pressing the special function button and select the option, descaling
(15.3). To confirm the option, press the special functions button (14) or the general options knob
(18).
84