Start / Stop; Advance Oven Function; Maintenance; Manual Cleaning - Fagor ADVANCE AG-061 Manual De Instalación, Uso Y Mantenimiento

START / STOP

4.1.10
The oven starts to operate with the settings entered in cooking, temperature
and time mode when the START/STOP button is pressed once.
If the button is pressed again, the operation is stopped and the oven is in pause
mode.
If a set time has been selected, pressing the START/STOP button a second
time implies that the cooking time is interrupted and the time is reset to the
previously selected value.
4.2

ADVANCE OVEN FUNCTION

Procedure to start a FAGOR ADVANCE oven.
1. Press the ON button (1).
2. Select cooking mode (4).
3. Select time (6).
4. Select temperature (8).
5. Select time/spike/delta function (10) (optional).
6. Press START/STOP (19).
4.3

MAINTENANCE

MANUAL CLEANING

4.3.1
The appliance should be cleaned every day.
For the correct working and maintenance of the appliance, it should be cleaned every day using
degreasing products specifically designed for this.
VERY IMPORTANT: Sand-based or abrasive products must not be used. Nor should a
hose be used to clean the outside of the appliance as this could affect the internal
components.
The appliance must always be switched off for Manual Cleaning.
WARNING: The detergents are highly active and therefore extreme caution should be
taken as they could cause irritation to the skin or eyes. The manufacturer's instructions must be
strictly observed.
When applying detergents and degreasing products, rubber gloves, face mask and protective
goggles must be worn, in accordance with the applicable safety regulations.
NOTE: The appliance has been designed to permit water to be sprayed all over the cooking chamber
without any risk of damage, to allow thorough cleaning and the perfect rinse.
If the oven is cleaned everyday, the operation can be completed quickly, giving an appliance in
perfect condition and ready for use the next day.
As the door reverse is made of glass, it is very easy to clean, using the same products used to clean
vitroceramic hobs.
1 Use the scraper to remove any grease incrusted on the glass.
2 Spray the product on the glass.
3 Wipe the glass clean with a cloth.
NOTE: Do not use products or tools which may scratch the glass.

PROBLEMS

4.3.2
In the event of a fault or the incorrect operation of the appliance, before calling the technical
assistance service, please check that:
87