Setting The Product; Setting The Application Type With Grundfos Go Remote; Setting The Sensor Type; Setting The Start Level - Grundfos LC 241 Manual Del Usuario

6. Setting the product

Make sure that all settings are entered according to the
pump and system requirements to avoid malfunction.
6.1 Setting the application type with Grundfos GO
Remote
1. Go to Settings > Level control > Application type.
2. Select the type.
• Empty
• Fill
Related information
3.3 Startup wizard on the operating panel
4.4 Application types

6.2 Setting the sensor type

6.2.1 Setting the sensor type with Grundfos GO Remote
1. Go to Settings > Level control > Sensor type.
2. Select the type.
• Analog sensors
• Digital sensors
6.2.2 Setting the sensor type with the operating panel
1. Press and hold OK until S-1 or S-2 starts flashing.
2. Select the sensor type using the Up and Down buttons.
• S-1: Analog sensors -
• S-2: Digital sensors -
3. Press OK to confirm the setting.
4. Continuously press OK to confirm all other settings and exit the
setup.
1 Submersible pressure transducer
2 Ball floats

6.3 Setting the start level

6.3.1 Setting the start level with Grundfos GO Remote
The settings apply to analog sensors. For digital sensors, the
setting is automatically activated.
1. Go to Settings > Level control > Start level P1.
2. Set the start level for pump 1.
3. Go to Settings > Level control > Start level P2.
4. Set the start level for pump 2.
6.3.2 Setting the start level with the operating panel
The settings apply to analog liquid level sensors. For digital
sensors, the setting is automatically activated.
1. Press and hold OK until the display and dry-running light start
flashing.
2. Continuously press OK until the indicator light for the start level
for pump 1 starts flashing.
3. Set the start level for pump 1 by using
the Up and Down buttons.
4. Press OK.
The indicator light for the start level for pump 2 starts flashing.
5. Set the start level for pump 2 by using
the Up and Down buttons.
6. Continuously press OK until the display stops flashing.
The settings have now been saved.

6.4 Setting the stop level

6.4.1 Setting the stop level with Grundfos GO Remote
The settings apply to analog liquid level sensors. For digital
sensors, the setting is automatically activated.
The stop level is the same for pump 1 and pump 2.
1. Go to Stop level> Settings > Level controlSettings
2. Set the stop level.
If you use the same level for start and stop,
remember to set a stop delay. This will prevent the
pump from starting and stopping too frequently.
6.4.2 Setting the stop level with the operating panel
The settings apply to analog liquid level sensors. For digital
sensors, the setting is automatically activated.
The stop level is the same for pump 1 and pump 2.
1. Press and hold OK until the display starts flashing.
17