diversey Taski swingo 2100µicro Traducción De Las Instrucciones Originales De Uso página 13

Notice:
The supply volume of the cleaning solution is ad-
justed to the corresponding working speed. (Intelli-
Flow)
Caution:
When working in restricted or narrow areas, it is
recommended to press the slow approach ON/OFF
button. (Display lights up)
This reduces the maximum working speed, thus also re-
ducing the risk of accidents.
• Pressing this button once more will
override this restriction and the dis-
play will disappear.
Battery capacity - end of operational readiness
The battery level indicator provides information on the available oper-
ating time.
• If the red indicator begins to flash, approx. 5 minutes of
working time are left.
• After this period, the brush unit and – 30 seconds later –
the squeegee is lifted. The red display switches to a contin-
uous light.
• Now you have 10 minutes to drive the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in several work
steps.
Notice:
More precise details regarding the direct and indi-
rect working method can be found on the respec-
tive method sheet.
- Please contact your TASKI customer consultant for
further details.
Adjustment of the squeegee for indirect working method
• Manually push the squeegee up-
wards until the position pin passes
through the position lock.
12
• Press the position lock to the right to
fix the squeegee.
Notice:
In some circumstances, certain combinations of
flooring/soiling and cleaning products may impair
the guiding of the machine.
- Optionally available wheels can improve the ma-
chine's traction on the floor. Please contact your TAS-
KI customer consultant.
Replenishing cleaning solvent
Caution:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
The pump must never run dry for an extended peri-
od.
Notice:
A rattling sound of the pump indicates that the
fresh water tank is empty.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 10.
• Add the cleaning product with the dosing cup or set the de-
sired dosage with the automatic dosing system (Intel-
liDose).
• Close the tank cover.
Empty recovery tank
Recovery tank full:
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 13.