Cub Cadet L20 Manual Del Usuario página 23

Ocultar thumbs Ver también para L20:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 108
Servicing
Attention!
Fuel may run into the combustion chamber.
ÂDamage to engine
¾ The mower must not be tilted to an angle greater
than 30°.
Bring the cutter deck to the top position.
Î
Clean the cutting chamber with a scrubbing brush,
Î
hand brush or a cloth.
Cutting mechanism with cleaning nozzle
(optional) W
Cleaning
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
Î
pling to attach a water hose.
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
Î
minutes.
Switch the engine and cutter deck off.
Î
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
Î
deck to run for a few minutes.
Switch the engine and cutter deck off.
Î
Cleaning the grass catcher
Attention!
¾ Note the separate operating instructions for the
grass catcher.
Detach the grass catcher and empty it.
Î
Clean the grass catcher with a powerful water jet
Î
(e.g. with a garden hose).
Allow the grass catcher to dry thoroughly before
Î
next use.
Starting the device
Observe the servicing instructions in the engine
Î
manual.
At the end of the season, have the mower in-
Î
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Return used batteries to your dealer or a dis-
posal company. Remove the battery in the
device before the device is scrapped.
Using jump leads
Risk of explosion / short-circuit
¾ Never bypass a defective or frozen
battery with jump leads.
¾ Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive terminal
Î
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Connect the black jump lead first to the negative
Î
terminal (–) of the donor battery.
Attach the other terminal on the frame near to the
Î
engine block of the lawn tractor as far away from
the battery as possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the lawn tractor.
Î
Switch the parking brake on.
Î
Disconnect the jump leads in reverse sequence.
Î
Tyre pressure
Increased tyre pressure
ÂRisk of accident and damage to the
device
¾ Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where
Î
necessary.
Front
0.9 bar
Rear
0.7 bar
Note
Excess tyre pressure reduces the service
life of the tyres. Check tyre pressure prior to
each journey.
DANGER!
WARNING!
EN
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

769-11724fXz3Xt3qr95

Tabla de contenido