Display Cluster (Depending On The Model; Optional) - Cub Cadet L20 Manual Del Usuario

EN
Switching the differential lock on and off
(model-dependent) A
An activated differential lock has a strong
influence on the steering performance of
the device.
ÂRisk of injury and damage to the device
¾ Only use the differential lock when
absolutely necessary; e.g. on difficult
terrain.
¾ Only activate the differential lock when
the device is at a standstill.
¾ Do not use the differential lock on paved
pathways or downhill.
¾ Only drive straight when the differential
lock is activated.
¾ Only drive slowly with the differential lock
activated.
With the differential lock activated, power is
transmitted to both rear wheels. The differential lock
intervenes if different wheel speeds are detected.
Stop the device.
Î
To activate the differential lock, step on the
Î
pedal N.
To deactivate the differential lock, take your foot
Î
back off the pedal N.
Note
If the differential lock does not release im-
mediately, reduce the speed of the device or
bring the device to a standstill.
Switching the device off
Stop the device.
Î
Switch the cutter deck off.
Î
Set the throttle to the middle position.
Î
Bring the cutter deck to the top position.
Î
Switch the engine off after 20 seconds.
Î
Switch the parking brake on.
Î
Remove the ignition key.
Î
Pushing the device
Note
The gear release lever is located between
the rear panel and the device's right rear
wheel.
20
WARNING!

Display cluster (depending on the model; optional)

Devices with differential lock Ka
Switch the engine off.
Î
Switch the parking brake off.
Î
Pull the gear release lever out fully.
Î
3 You can now push the device.
Note
Before you start the engine, press the gear
release lever back in fully.
Devices without differential lock Kb
Switch the engine off.
Î
Switch the parking brake off.
Î
Press the gear release lever in fully.
Î
3 You can now push the device.
Note
Before starting the engine, pull the gear
release lever out again fully.
12-volt socket (model-dependent) X
The socket [2] is used for connection of a 12 volt
battery charger or connection of miscellaneous 12
volt devices.
Note
Observe the corresponding information of
the battery charger or the 12 volt devices
that are to be connected.
Display cluster (depending on the model;
optional)
Note
The indicators only come on when the en-
gine is running.
Note
If an oil change and air filter maintenance
arise simultaneously, the oil change indicator
lights up first, then the air filter indicator.
Depending on the design, the indicator panel may
consist of the following elements:
Type 1 Oa in conjunction with the ignition
lock Ha
Operating hour counter
When the ignition is switched on, the battery voltage
indicator is displayed for a short period, which then
changes to the operating hours indicator.
The operating hours are always counted except
for when the ignition key is in the "Stop" position or
when it is removed.