Intended Use; Identification Plate; Safety Devices - Cub Cadet L20 Manual Del Usuario

Intended use

Intended use
This device is designed to be used
- As a lawn tractor for mowing grass areas of a
house or gardens.
- With accessories explicitly approved for this lawn
tractor.
- In accordance with the descriptions and safety
instructions given in these operating instructions.
Any other use is classed as an unintended use.
Improper use is not covered by the warranty and
the manufacturer will reject any liability. The user is
liable for injuries to third parties and damage to their
property.
Unauthorised changes to the device exclude liability
of the manufacturer for any resulting damage and/
or injury.
This device is not approved for operation on public
roads, nor for transporting people.

Identification plate

Position
The identification plate is located under / in front of
the driver's seat.
Note
The identification is considered as a docu-
ment. It must never be altered or obliterated.
MODEL NUMBER
1
XXXXXXXXXXX
2
XXXXXXXXX
3
XXX KG
4
XXX
10
Layout
1 Model number
2 Model name
3 Weight
4 CE mark
5 Manufacturer
6 Device group
7 Engine power / engine speed in rpm
8 Serial number
9 Year of construction
10 Guaranteed sound level
9
DOM SERIAL NUMBER
XX/XXXX XXXXXXXXXXX
XX,X KW XXXX/MIN
XXXXXXXX
MTD PRODUCTS AG
INDUSTRIESTR. 23
D 66129 Saarbrücken
Grass catcher S
Contact with the cutting blade and items
flung out
ÂRisk of injury
¾ Only operate the device with the grass
catcher attached or an optional deflector.
Safety locking system
The safety locking system will only allow the engine
to start when
- The driver is sitting on the seat.
- The brake pedal has been depressed or the park-
ing brake is in the park position.
- The accelerator pedal is at "N".
- the cutter deck has been switched off; i.e.: PTO
switch set to "O/Aus/Off" (PTO = Power-Take-Off).
The safety locking system prevents mowing without
the grass catcher attached or without the optional
deflector attached (automatic engine or cutting
mechanism deactivation).
In devices with a PTO switch (electromechanical
PTO), the safety locking system automatically
switches off the cutting mechanism once the
operator leaves the seat with the cutting mechanism
activated; irrespective of whether the parking brake
was activated beforehand.
In devices without an OCR function or with a
8
deactivated OCR function, the safety locking
7
6
system prevents reversing with the cutting
mechanism activated (automatic shutdown of engine
or cutting mechanism).
Prior to reversing on devices with PTO, switch off
Î
5
the cutting mechanism using the PTO switch.
Note on devices with a PTO switch
In the case of automatic shutdown through
the safety locking system (e.g. reversing or
leaving the seat with the cutting mechanism
activated), first switch the switch off, and
then back on again, to release the clutch
lock (PTO).

Safety devices

CAUTION!
EN
13