Installation; Diagram Of The Control Unit And Electrical Connections - EB TECHNOLOGY START-S3XL-K Manual De Instrucciones

START-S3XL-K
2

Installation

2.1

Diagram of the control unit and electrical connections

8 9 10 11
ON
J-R
1 2 3
1 2 3 4 5 6
Connection of the NETWORK
POWER SUPPLY
230 Volt Single-phase alternate
current. The control unit power sup-
ply line must always be protected
with a magnetothermal switch or a
pair of 5A fuses.
A diff erential switch is recommen-
ded but not indispensable if one is
already installed on the plant.
12 13 14 15 16 17 18 19
CTS
LED L1
4 5 6 7 8 9 10 11 12
7
1  2
J AC/DC
3  7
23
22
8  19
JP3 JP4
21
20
20  21
22  23
JUMPER
AC/DC
JUMPER
J-R
JP3 - JP4
DIP 1-10
DIP 11-12
Button P
When in doubt as to the correct connection, if
possible, manually position the automation at the
midpoint of its stroke. Be ready to stop the system
using the STOP control!
To be sure that the opening is really "opening", try
to block the photocells: if the gate begins to close,
the connection is incorrect and the motor OPEN
and CLOSE wires must be inverted.
-4-
control unit power supply 230Vac
power supply for motor and for 230Vac signal light
power supply voltage to accessories and to
service and safety inputs
dry contact for light or TEST for photocells or
signal light without fl ashing
stop coast input + inversion for 1.5 sec
output power supply selection 24Vac
or 24Vdc on terminals 18 and 19
activation or deactivation of the radio receiver
safety edge
function of the control unit
selection of the speed of slowing down or deacti-
vation of the slowing down
code learning, force adjustment, increase of the
pause time
Connection of the MOTOR
Pay particular attention not to invert
the OPEN and CLOSE poles.
Technical Manual