Remote Control Learning; Turning On And Programming The Unit - EB TECHNOLOGY START-S3XL-K Manual De Instrucciones

START-S3XL-K
4.3

Remote control LEARNING

The remote control code can only be learned when the automation is CLOSED
During the program, to avoid any interferences, we recommend to disconnect the antenna for
a while from the terminal board no. 8-9.
ON
1
4
1 2 3 4 5
>
2
P L1
3
4
- If you wish to learn a new remote control, repeat the operation from the fi rst step.
- if you don't need to assign any button to the PEDESTRIAN CHANNEL, don't follow the step no.4 and wait for 8 seconds and one
fl ash of LED L1 until it fl ashes regularly.
- If you press the button of the remote control and LED L1 is lit on the remote control is not compatible
- If you press the button of the remote control LED L1 fl ashes slowly it means that the memory is full
- You cannot cancel a single code in this control panel
5

Turning on and programming the unit

When the electronic circuit board is turned on, if everything has been connected properly, the red TEST signal light
must fl ash while the inputs STOP, PHOTO, LSO, LSC, STOP, ALT must remain on (if the gate is closed the LSC is
off ). The START and PED lights must be off . If, after being turned on, the motor starts opening, it means that the
electronic circuit board was previously turned off (depowered) while it was in the open position.
If the work times have not yet been set, you must: turn off the circuit board, set the automation in the closed
position, set the switch DIP1 to ON and repower the circuit board. Setting switch 1 (DIP1) to on the electronic
circuit board is activated in times learning mode. In this mode it is possible to set: motor work and pause times,
deceleration position for closing, activation or deactivation of the fl ashing light in pause mode.
Below you will fi nd the procedure to be used to learn times. To perform this operation, use the START and PEDE-
STRIAN commands. These commands can be used both from a device connected to terminals 9 - 16 or 9 - 17,
respectively, START and PEDESTRIAN opening (see "CONNECTION OF OPENING COMMAND" AND "CON-
NECTION OF PEDESTRIAN COMMAND"); it can also be connected from a transmitter which was previously
learned (see "LEARNING REMOTE CONTROLS").
According to the security norms and for a proper use of the control panel
it is important to set up all LIMIT SWITCHES (LSO and LSC)
Make sure that DIP switch 1 is set to OFF.
The automation is in the CLOSED position
Press push-button P on the circuit board.
LED L1 is lits on for 10 seconds waiting for a command
Press once and slowly release the remote control you wish to associate with the START
command. The TEST light fl ashes 6 times fast then 1 slow fl ash and then remains lit on
for 10 seconds.......(START Code learned!)
Press twice P, press and slowly release the wireless control key you wish to associate
with the PEDESTRIAN command (normally the second transmitter channel). LED L1 will
fl ash 6 more times and then go off and return to their normal functions.
-12-
Technical Manual