Times Learning With The "Pedestrian" Command - EB TECHNOLOGY START-S3XL-K Manual De Instrucciones

START-S3XL-K
5.2

Times learning with the "PEDESTRIAN" COMMAND

The PEDESTRIAN command is used to open the automation only partially to allow people and small vehicles to
pass through without having to open the gate completely. When opening is performed with this command, the
automation decelerates only when it is closing and following the setting previously acquired in the START
command programming.
ON
1
4
1 2 3 4
2
3
4
5
6
7
ON
8
2 3 4
1
5.3 ADJUSTMENT of the MOTOR FORCE
The electronic circuit board has 7 diff erent levels of force. To reduce the motor force press and release button P
WHILE the motor is working.When reached the 1st level it goes back to the 7th level. Each pression the motor force
is reduced of one level. When you press the button at the lowest level the force will be increased at the maximum
level. The adjustment is indicated from L1 (longer lighting)
!
The operation can only be performed while the motor
is running. This control unit has AUTOMATIC START.
Each time the motor starts up, the electronic circuit
board keeps the motor force for 2 seconds maximum
Switch off the power supply
Set switch DIP 1 to ON
5
Give power supply to the control panel. (The LED L1
light is off when the control unit is in programming mode)
Press the PEDESTRIAN command (everything con-
nected to input 17 or the 2nd channel of the compatible
remote control that has been learned)
Press the PEDESTRIAN command to stop the automa-
tion at the desired point (end of partial opening).
Let the time elapse during which the automation must
remain open.
Press PEDESTRIAN command to start closing
Wait for the automation to stop automatically
Set the switch DIP 1 to OFF to return to normal ope-
ration. The fl ashing light goes off and the LED L1 light
goes back on.
5
Force level after each
time the push-button
is pressed
-14-
Technical Manual
The automation
is in the CLOSED
position
The automation
starts in
OPENING mode
The automation
STOPS
This is the
automation
"PAUSE TIME"
The automation
starts in
CLOSING mode
The automation
is in the CLOSED
position
Time programming
has been completed
7
6
5
4
3
2
1
L1