CAEDEN 10 Serie Guia Del Usuario página 70

Pairing Your Linea No10 Pairing Your Linea No10
將 Linea Nº10 配對
Linea Nº10 Linea Nº10
Linea Nº 1 Linea Nº 1
Linea Nº2 Linea Nº2
按住 2 秒進
入配對模式。
The Linea No10 can store up to 8 Bluetooth The Linea No10 can store up to 8 Bluetooth
º
最多一次可記住之前 8 個
Linea N 10
hosts at one time. hosts at one time.
連接的裝置。
1. To power on and pair your headphones for the 1. To power on and pair your headphones for the
若是第一次開啟耳機的電源和進行配
1.
rst time, press and hold the rst time, press and hold the button for
CENTER CENTER
對，請按住「中央」按鈕 2 秒鐘。 LED
2 seconds. The 2 seconds. The will ash alternately will ash alternately
LED LED RED
and and 燈會交替性地亮紅燈和藍燈，以表示耳 to indicate that the headset is in to indicate that the headset is in
BLUE BLUE
pairing mode. pairing mode.
機正在配對模式。
2. Open the Bluetooth 2. Open the Bluetooth settings on your settings on your
® ®
2. 在您的智慧型手機、平板電腦、電
smartphone, tablet, computer or other mobile smartphone, tablet, computer or other mobile
腦或其他行動裝置上開啟藍牙 ® 設定。
device. Follow your device's pairing instructions device. Follow your device's pairing instructions
and select the device named "Linea No10." and select the device named "Linea No10."
依照裝置的配對指示並選名為「 Linea
º
」的裝置。
N 10
3. The 3. The will blink will blink twice to indicate that twice to indicate that
LED LED BLUE BLUE
the Linea No10 is paired with your device. the Linea No10 is paired with your device.
會閃藍燈兩次，以表示 Linea
3. LED
º
N 10 已經與您的裝置配對。
® ®
button for
RED
4. To pair your Linea No10 with another device, 4. To pair your Linea No10 with another device,
4. 若要將 Linea Nº10 與另一個裝置配
start with the headset in power start with the headset in power
對，請先從關閉電源的耳機開始。按住
the the button for 6 seconds. The button for 6 seconds. The
CENTER CENTER
「中央」按鈕 6 秒鐘。LED 燈會交替
ash alternating ash alternating and
RED RED
is ready to is ready to pair. pair.
性地閃爍紅燈和藍燈，以表示耳機已經
Note: When more than 8 hosts are paired, the oldest paired Note: When more than 8 hosts are paired, the oldest paired 準備好進行配對。
device will be automatically dropped when a new device is device will be automatically dropped when a new device is
paired. You may completely clear the list of stored devices by paired. You may completely clear the list of stored devices by
附註：如果配對的裝置超過 8 個，則會在與新裝置配對
pressing pressing & &
VOLUME UP VOLUME UP VOLUME DOWN
按住 6 秒與另
until the until the ashes ashes &
時，自動捨棄最早配對的裝置。您也可以完全清除所儲存
LED LED RED BLUE RED
一個裝置配對。
的裝置清單，方法是在開啟電源的情況下，同時按下「調
升音量」和「調降音量」按鈕，直到 LED 燈閃爍紅燈和
藍燈兩次為止。
º
Linea N 10：
The Linea No10 is: The Linea No10 is:
處於配對模式
in pairing mode. in pairing mode.
已與裝置配對
paired with your device. paired with your device.
× 2 × 2
mode. Hold mode. Hold
OFF OFF
will will
LED LED
and to indicate that it to indicate that it
BLUE BLUE
, while the power is on, , while the power is on,
VOLUME DOWN
& twice. twice.
BLUE