Cleaning The Nozzle; Cleaning With Compressed Air; Storage; Disposal - Parkside PDRP 6.2 B2 Traducción Del Manual De Instrucciones Original

■ Check the compressed air cleaning gun regu-
larly for possible cracks, damage and smooth
operation of the nozzle
■ The compressed air cleaning gun may not be
used if there are any abnormalities. In this is the
case, please contact a specialist.

Cleaning the nozzle

♦ If the nozzle is badly soiled, unscrew the
brush by turning it anticlockwise. Remove the
nozzle and clean it with fresh water.

Cleaning with compressed air

NOTE
► As an exception, connect the appliance to
the compressed air supply for subsequent
cleaning work. Afterwards, disconnect the
appliance from the compressed air supply.
♦ Turn the valve to the horizontal position and
pull the trigger to clean the nozzle
compressed air.
♦ Use fresh water to clean the compressed air
cleaning gun, but never aggressive cleaning
agents. Turn the valve
position, so that when the trigger
only air comes out.
Dip the compressed air cleaning gun with the
brush into a container filled with fresh water.
Pull the trigger to remove the dirt from the
brush and nozzle
│ GB │ IE
■ 8
.
with
to the horizontal
is pulled,
.

Storage

♦ Store the compressed air cleaning gun in a dry,
clean and frost-proof location.

Disposal

The packaging consists of environmen-
tally friendly material. It can be dis-
posed of in local recycling containers.
Do not dispose of the appliance in the normal
domestic waste!
Dispose of the packaging in an environ-
mentally friendly manner. Note
the labelling on the packaging and
separate the packaging material com-
ponents for disposal if necessary. The packaging
material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product.
The product is recyclable, subject to
extended producer responsibility and
is collected separately.
PDRP 6.2 B2