Operation; Requirements At The Place Of Use; Setting Up The Charging Station; Charging The Batteries - Heiniger XPLORER Traducción Del Manual Original

When storing longer than 3 months, check periodically the general con-
X
dition of all parts.
When not using the clipper, store it in the case making sure it is well
X
cleaned, lubricated and that the clipping elements are not spring loaded
(risk of corrosion).
6

Operation

6.1

Requirements at the place of use

Observe the manual (see chapter Specifications).
X
Power outlets in the outer area must be equipped with a residual current
X
circuit breaker (FI).
The work place must have adequate lighting.
X
The electrical socket must be easily accessible so that the device can be
X
quickly disconnected from the mains.
The location of installation must be out of reach of children.
X
The charger power cord must not be taut or kinked.
X
Make sure there is adequate ventilation.
X
6.2

Setting up the charging station

Fig. 3
6.3

Charging the batteries

1
Fig. 4
12
Translation of the original instructions / Cattle and Horse Clipper
2
3
1
Position the charger (1) on a fixed,
X
level, dry and clean surface.
Connect the power supply unit (2) to
X
the charger.
Plug the power supply unit into the
X
power socket.
The continuous green light on the lower
X
LED (3) signals that the power supply
unit is correctly plugged into the power
socket and the charger is supplied with
power. The charger is ready to operate
(see also chapter 6.4).
Press both sides of the battery
X
latch (1) and remove the battery.
Check the battery terminals for for-
X
eign objects and dirt.