Lubrication - Heiniger XPLORER Traducción Del Manual Original

Fig. 13
Fig. 14
NOTE!
Only work with sharp blades, replace blunt or defective blades
X
without teeth. The correct resharpening of blades is only to do
by special machines or by a specialist. In that case, contact
your service centre.
6.9

Lubrication

Fig. 15
CAUTION!
POSSIBLE DAMAGE TO THE CLIPPER!
Insufficient oiling of the clipping head will lead to warming and will
shorten the life of the clippers and its blades.
Oil the clipping blades adequately during the clipping session,
X
at least once every 15 minutes, so that they do not run dry.
16
Translation of the original instructions / Cattle and Horse Clipper
Place the new upper blade on the
X
guiding tips of the pivot lever.
Apply a few drops of oil on the pol-
X
ished surfaces of the upper blade.
Install the new lower blade. Align it so
X
that the ground surface of the lower
blade protrudes approx. 1.5 - 2 mm
above the point of the upper blade.
Tighten the comb plate screws.
X
To achieve a well-clipped animal and to
increase the life of the device including
the clipping head, it is necessary to
apply a thin coat of oil between the
upper and lower blades. All other moving
parts of the clipping head must also be
lubricated.
Apply some drops of oil on to the
X
clipping blades and into the lubrica-
tion opening.