Status Display (Leds); Operation - Bosch KTS 560 Manual Del Usuario

en | 18 | KTS 560 / 590 (KTS 5a Series) | Device description
Fig. 4: Connection panel with protective cap
i
The protective cap included in the scope of delivery
protects the connection panels against mechanical
damage, soiling or water.
3.5.3

Status display (LEDs)

1 2
6
Fig. 5: Status display (LED)
1 ON/OFF LED
2 ERROR LED
3 USB LED
4 BLUETOOTH LED
5 DIAGNOSTICS LED
6 "Recovery mode" key
ON/OFF LED Function
Green light KTS 560 / 590 is ready for operation.
Flashing KTS 560 / 590 is only connected via the USB
green connection cable (power supply via mains
adapter or OBD connection cable is missing).
KTS 560 / 590 is not ready for use.
Off No voltage supply.
ERROR Function
LED
Off No error
Red light Hardware/firmware
problem
Voltage supply > 36 V
"Recovery mode" activated Carry out recovery.
USB LED Function
Off No data communication via USB.
Flashing green Data communication via USB.
|
1 689 989 223 2021-09-24
3 4 5
459963-09_Ko
Measure
None.
Remove the USB
connection cable
and voltage supply
and reconnect.
Perform firmware
update.
Test the power
supply.
BLUETOOTH LED Function
Off No data communication via Bluetooth.
Flashing green Data communication via Bluetooth.
DIAGNOSTICS LED Function
Off No data communication with control unit.
Green light Data communication with control unit.
"Recovery mode" key
i
The "Recovery Mode" key is only used to perform
a firmware update of KTS 560 / 590 in the case of
malfunctions.
After the "Recovery Mode" key is pressed > 3 seconds,
the ERROR LED lights up red and the firmware can be
updated via DMC (Diagnostic Module Configuration).
After a firmware update, the ERROR LED must
extinguish.
If the firmware is not updated after the "Recovery
mode" key is pressed, the voltage supply and the USB
connecting cable must be disconnected. After the
voltage supply is reconnected, the ERROR LED must
be off again.
3.6

Operation

The KTS 560 / 590 can be connected to a PC/
laptop by way of a radio link (Bluetooth) or the USB
interface. For a radio link, the Bluetooth USB adapter
has to be plugged into the PC/laptop.
i
The radio link between the KTS 560 / 590 and
the PC/laptop can only be established using the
Bluetooth USB adapter included in the scope of
delivery.
i
In the event of problems with the Bluetooth
wireless connection, refer to the information in
sec. 2.6.
i
The Bluetooth USB adapter supplied is not required
for a DCU 100 / 220 with internal Bluetooth
hardware.
Robert Bosch GmbH