Safety Notes; Correct Use - SICK WSE100-2 Manual De Operación

2

Safety notes

3

Correct use

4 Commissioning
Read the operating instructions before commissioning.
■
Connection, mounting, and setting may only be performed by trained specialists.
■
Not a safety component in accordance with the EU Machinery Directive.
■
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of the sensor.
■
The WS/WE100-2 is an opto-electronic through-beam photoelectric sensor (referred to as "sen‐
sor" in the following) for the optical, non-contact detection of objects, animals, and persons. A
sender (WS) and a receiver (WE) are required for operation. If the product is used for any other
purpose or modified in any way, any warranty claim against SICK AG shall become void.
1 Observe the application conditions: Adjust the distance between the sender and the recei‐
ver according to the corresponding diagram (x = sensing range, y = operating reserve).
If several through-beam photoelectric sensors which are installed next to one another are to
be used, we recommend swapping the sender/receiver arrangement at every second
through-beam photoelectric sensor and ensuring that there is sufficient distance between
the through-beam photoelectric sensors. By doing this, mutual interference can be preven‐
ted [cf. F].
Through-beam photoelectric sensor
Operating instructions
8017528 | SICK 1