Hold Function - Soehnle Professional 7730.65 Instrucciones De Uso

5.6

Hold function

40
Delete tare
Press the zero reset key to delete the tare.
Tare info
Pressing and holding the zero reset key displays the tare weight.
Briefly pressing deletes the tare weight; pressing and holding until the
weight display blinks does not delete the tare weight.
Dialysis function (interim tare function)
The function key can be programmed with a dialysis function.
See user mode 3710 for programming the function key (see separate
description 470.702.099)  UCAL 4 Pos. 02 = value 5.
Unknown tare values are added to the stored tare value without
changing the net display.
After the function key is pressed, the display shows "hold".
Place additional tare weight or remove tare weight from platform.
The new tare value is stored with the print key.
The hold function is assigned to the function key in setup mode. See
user mode 3710 for programming the function key (
description 470.702.099)
In weighing mode, the hold function is enabled by pressing the function
key.
The following hold functions are available to freeze weight data. Default
is "0".
The hold function is programmed in setup mode (see separate
description 470.702.099 user mode 3710)  UCAL 1 Pos. 02.
Hold mode Function
0 Inactive
1 Hold at rest
2 Hold at rest
3 Max. value
4 Max. value
5 Slave display
6 Slave display
The hold mode is disabled with the function key.
 UCAL 4 Pos. 02 = value 1.
Cancel function
On/Off key
Removal of load from scale
On/Off key
Removal of load from scale
On/Off key
Removal of load from scale
www.soehnle-professional.com
see separate