Installation; Installing The Cot Fastener - Stryker M-1 Manual Del Usuario

Installing the cot fastener

English
EN
The Stryker Model 6373, 6376, and 6381 cot fastener systems are compatible only with cots that conform to the
installation specifications. Cots that meet these specifications include:
• Stryker Model 6100 M-1 Roll-In System
• Ferno-Washington Model X-2
WARNING
• Always replace the cot fastener if it has been involved in an accident to avoid the risk of injury due to product
damage.
• Always make sure that all cots meet the installation specifications for the Stryker cot fastener system.
CAUTION
The cot fastener system must be installed by qualified personnel. 1/4" steel backing plates (or equivalent) are required
beneath the mounting surface (ambulance floor or tray system) at all mounting points.
For more information about the Stryker cot fastener systems, see the Cot Fastener Operations and Maintenance
Manuals.
1
2000 model year or earlier. Stryker is not responsible for changes in specifications to other manufacturer's cots.
1-12

Installation

1
Figure 1-2: Model 6376: View 2A
Figure 1-3: Model 6376: View 2B
6100-109-005 REV B www.stryker.com